Here is some additional information on how you can make the most of your Watch Band Storage Case!
The Watch Band Storage Case does not come with watch bands. Pictures showing watch bands are for illustration purposes only.
When you receive your Storage Case, unzip to open the case. Inside you will find a piece of rigid foam - this is the most essential part of the Storage Case (do not throw it out). Install the foam as follows:
Take the foam out of the storage case and remove the rectangular pieces from each compartment. Each rectangular compartment can store roughly 5 watch bands, so remove the number of rectangles based on how many watch bands you wish to store (e.g. remove 2 blocks if you wish to store up to 10 bands).
Don't worry, you can put the blocks back into place (or remove more blocks) later as needed.
Once the pieces are removed, turn the block over to expose the sticky side. You may have wax-paper over the sticky side (if so, remove the wax-paper).
Put the sticky-side face down (to stick to the inside of the case). Gently push down to ensure the foam adheres to the case's inner lining.
There are three different sections inside the Storage Case to perfectly organize your watch bands.
There are 3 slots, with elastic straps and small mesh pockets. This is a great place to store fragile bands, to keep these bands from rubbing and scratching against other bands or items.
You can use the middle area to store the watch band tools and other accessories for your Apple Watch such as the cable charger.
Each of these foam compartments can store up to 5 watch bands. This photo shows how we can arrange the band in order to fit up to 25 watch bands. The actual number of bands you can store will depend on the thickness and size of each band.
Storage Case will get dirty over time. Dust, oils, and stains can affect the look of your storage case. How often the storage case needs to be cleaned depends on your situation.
To clean the storage case:
If you have any other questions about your watch band, please contact us.